Welsh Blue Slate Floor Tiles - Ceramic or porcelain tile flooring is extremely durable and a great investment in your home. Tiles will last forever when they are looked after, and practically never wear out. When you're getting ready to install the tile flooring that you'll need to get the ceramic or porcelain tiles, cement backer board, tile nippers, sponges, tape measure, knee pads, tile cutter or tile saw, grout, square, rubber float, chalk line, a great deal of water, eye protection, thin set, pails, hammer, notched trowel, and nails.
You'll need to remove all the molding and baseboards. Eliminate wooden floorings, carpet, or any existing floor coverings. Clean the subfloor it's free of debris and dust. Make sure the flooring is tough and secure. Install cement backer board onto the flooring that was stabilized and at each floor joist screw, the backer board in with 2 inches galvanized screws. The old flooring will have to be disposed of, and items that are such are not picked up by most trash services.
Work with a chalk line to mark two lines that intersect in the middle of the area. Ensure the lines are square to every other (90 degrees). Set spacers between the tiles, leaving enough room for the grout. Look at the way the tiles are arranged; you need as many entire tiles in the center as possible. Until you are satisfied with the way they can be placed fiddle with all the tile.
Use thin set to hold your tiles in place. Make use of a notched trowel. Disperse the thin-place merely to as far as you are able to comfortably reach and put a tile. Install your tiles into the inset with a strong downward pressure. Don't forget to place spacers involving the tiles. You're able to harness on the tile on the corners gently to be certain that it's in place. Begin at the centre and work out to the walls. Border tiles and the cut tiles are installed last.