Kitchen Floor Tiles Design - Ceramic or porcelain tile flooring is extremely durable and an excellent investment at home. Tiles never wear out, and almost will continue forever if they're taken good care of. When you are getting ready to put in the tile flooring you will need to get the ceramic or porcelain tiles, cement backer board, tile nippers, sponges, tape measure, knee pads, tile cutter or tile saw, grout, square, rubber float, chalk line, lots of water, eye protection, thin set, pails, hammer, notched trowel, and nails.
You'll need to remove all of the molding and baseboards. Remove any existing floor coverings, carpeting, or wooden floorings. Clean the subfloor it is free of debris and dust. Make sure that the floor is secure and tough. Install cement backer board onto the floor that was stabilized and at every floor joist screw, the backer board in with 2 inches galvanized screws. The old flooring will have to be disposed of, and things that are such are not picked up by most garbage services.
Utilize a chalk line to mark two lines that intersect in the middle of the area. Make sure the lines are square to each other (90 degrees). Set a row of tiles along both lines on the floor that was dry. Put spacers between the tiles, leaving enough room for the grout. Look at the way the tiles are ordered; you need as many whole tiles in the middle as you can. Until you're satisfied with the way they may be placed fiddle with all the tile.
Use thin set to hold your tiles set up. Use a notched trowel. Distribute the thin-set only to as far as it is possible to comfortably reach and lay a tile. Install your tiles to the inset with a strong downward pressure. Remember to place spacers involving the tiles. You're able to exploit on the tile gently to be certain that it is in place. Begin at the center and work out to the walls. Border tiles and the cut tiles are installed.