Diamond Plate Metal Interlocking Floor Tiles - Porcelain tile flooring or ceramic is extremely durable and a great investment at home. Tiles never wear out, and practically will last forever if they can be taken care of. When you are preparing to put in the tile flooring you will need to get the ceramic or porcelain tiles, cement backer board, tile nippers, sponges, tape measure, knee pads, tile cutter or tile saw, grout, square, rubber float, chalk line, a great deal of water, eye protection, thin set, buckets, hammer, notched trowel, and nails.
Eliminate any existing floor coverings, carpet, or wooden floors. Clean the subfloor it is free of dust and debris. Make sure that the flooring is sturdy and secure. Install cement backer board onto the stabilized flooring and the backer board in with 2 inches, at each floor joist screw galvanized screws. The old flooring will have to be disposed of, and most garbage services don't pick up such things.
Work with a chalk line to mark two lines that intersect at the center of the region. Make certain the lines are square to each other (90 degrees). Place a row of tiles along both lines on the floor that was dry. Put spacers between the tiles, leaving enough room for the grout. Look at the way the tiles are ordered; you want as many whole tiles in the middle as possible. Fiddle with all the tile before you're happy with the way they may be positioned.
Use set to hold your tiles in place. Use a notched trowel. Disperse the thin-place just to as far as you are able to comfortably reach and lay a tile. Install your tiles to the inset using a strong downward pressure. Remember to put spacers involving the tiles. It's possible for you to harness the tile on the corners gradually to ensure that it is in place. The cut tiles and border tiles are installed.
Related Post "Diamond Plate Metal Interlocking Floor Tiles"