Silver Gray Floor Tiles - Porcelain tile flooring or ceramic is very durable and also an excellent investment in your home. Tiles will last forever if they have been looked after, and almost never wear out. When you are getting ready to put in the tile flooring you will need to get the ceramic or porcelain tiles, cement backer board, tile nippers, sponges, tape measure, knee pads, tile cutter or tile saw, grout, square, rubber float, chalk line, a lot of water, eye protection, thin set, pails, hammer, notched trowel, and nails.
Eliminate wooden floorings, carpet, or any existing floor coverings. Clean the subfloor making sure it's free of debris and dust. Make sure the flooring is tough and stable. Install cement backer board onto the flooring that was stabilized and at each floor joist screw, the backer board in with 2 inches galvanized screws. The old flooring will need to be disposed of, and most garbage services don't pick up things that are such.
Use a chalk line to mark two lines that intersect in the middle of the area. Make certain the lines are square to each other (90 degrees). Place a row of tiles along both lines on the floor that was dry. Look at how the tiles are ordered; you need as many entire tiles in the centre as you possibly can. Before you're pleased with the way they're positioned, fiddle with all the tile.
Use thin set to hold your tiles set up. Utilize a notched trowel to spread the thin set. Disperse the thin-place only to as far as you can reach and place a tile. Install your tiles into the inset with a firm downward pressure. Don't forget to put spacers involving the tiles. It's possible for you to harness on the tile on the corners gently to make certain that it's in place. Border tiles and the cut tiles are installed.