Calcutta Marble Floor Tiles - Porcelain tile flooring or ceramic is very durable as well as a great investment at home. Tiles never wear out, and practically will continue forever if they have been taken good care of. When you're preparing to install the tile flooring you will need to get the ceramic or porcelain tiles, cement backer board, tile nippers, sponges, tape measure, knee pads, tile cutter or tile saw, grout, square, rubber float, chalk line, a great deal of water, eye protection, thin set, pails, hammer, notched trowel, and nails.
You will need to remove all of the molding and baseboards. Remove wooden floorings, carpeting, or any existing floor coverings. Clean the subfloor making sure it's free of debris and dust. Make sure the flooring is sturdy and stable. Install cement backer board onto the flooring that was stabilized and at every floor joist screw, the backer board in with 2 inches galvanized screws. The old flooring should be disposed of, and most garbage services do not pick up such things.
Utilize a chalk line to indicate two lines that intersect at the center of the region. Make certain the lines are square to each other (90 degrees). Place a row of tiles along both lines on the dry floor. Place spacers between the tiles, leaving enough room for the grout. Look at the way the tiles are ordered; you need as many whole tiles in the center as you possibly can. Until you're content with the way they may be placed, fiddle with the tile.
Use thin set to hold your tiles set up. Make use of a notched trowel to spread the thin set. Spread the thin-set simply to as far as you can comfortably reach and place a tile. Install your tiles into the inset with a firm downward pressure. Don't forget to place spacers between the tiles. You can harness on the tile gradually to make sure that it is in place. Start at the centre and work out to the walls. Border tiles and the cut tiles are installed.